Jump to content

Civil 3d, Ditch subassembly in fill condition

Benjamin

By Benjamin
in Civil 3D & LDD

 Share

Recommended Posts

Benjamin Newbie

Benjamin

Posted
Posted

Hi!

My question is the following: Can C3d be forced to place a ditch on the side slope of an embankment?  I need to give continuity to a ditch that comes from a cut condition until reach the discharging point.  I tried using the BasicSideSlopeCutDitch command to do it, but i can't.  Do you have any advice?

Thank you, for your help!

Benjamin

  • 1 month later...
CyberAngel Grand Master

CyberAngel

Posted
Posted

Have you tried the DaylightBasin subassembly? You can pretend your ditch is a basin and interrupt the slope, then continue the slope to the existing grade. You can define the slope or the width of either side of the ditch.

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing
×
×
  • Create New...