harrisnel Posted December 20, 2021 Posted December 20, 2021 I am new Here and Do not have Enough Experience Is someone can help me to draw a paddle board 3D in a Few Minutes. Quote
ReMark Posted December 20, 2021 Posted December 20, 2021 (edited) Draw the 2D outline of a paddleboard using a polyline. Extrude it. Then using the Fillet command apply a radius to the top and bottom edges of the paddleboard. Done. Edited December 21, 2021 by ReMark Quote
lrm Posted December 20, 2021 Posted December 20, 2021 Start with two views of the paddleboard and create a region from a spline for half of the top (or bottom) view and the full side view. Extrude the two regions and rotate the profile solid so that it intersects the extruded top view. Execute a Boolean intersect. to get half of the board then mirror and union to get a single solid of the board. 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.