toanuea.christopher Posted March 19, 2021 Share Posted March 19, 2021 Good morning all.. I was just wondering if someone would have blocks for all Ductile Iron Fittings that I could use... Bends valves, T-Juctions etc. Any help will be highly appreciated. Quote Link to comment Share on other sites More sharing options...
BIGAL Posted March 20, 2021 Share Posted March 20, 2021 You need to advise where you are in the world so correct PIPE STD is met. I do not have any. ISO BS AS US etc 1 Quote Link to comment Share on other sites More sharing options...
nukecad Posted March 21, 2021 Share Posted March 21, 2021 (edited) As BigAl says there are many different piping standards around the world. Take a look if these are of any use to you, there is more stuff further up that thread:https://www.cadtutor.net/forum/topic/12856-mampe-draughtsmen/page/2/?tab=comments#comment-109430 Edited March 21, 2021 by nukecad 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.