chubarka Posted February 23, 2021 Share Posted February 23, 2021 Will one of you Guru's here tell me why my small selection square will not land on a line for me to select, but rather jumps all around it. I am trying to put a fillet between two lines forming a corner and the small selection square that comes up will not allow me to select the lines, but lands on either side of the line. I am new to Autocad. Thank you in advance, Chubarka Quote Link to comment Share on other sites More sharing options...
rkmcswain Posted February 23, 2021 Share Posted February 23, 2021 (edited) It sounds like you have SNAP enabled. By default, the F9 key will toggle SNAP on and off. Tap the F9 key and try again. Edited February 23, 2021 by rkmcswain add URL 1 Quote Link to comment Share on other sites More sharing options...
chubarka Posted February 24, 2021 Author Share Posted February 24, 2021 Thank you so much! Quote Link to comment Share on other sites More sharing options...
Dadgad Posted February 24, 2021 Share Posted February 24, 2021 BINGO! @rkmcswain nailed it! Having GRID turned on can also potentially lead to selection problems, dependent upon the scale of your Grid. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.