Cad64 Posted July 22, 2020 Posted July 22, 2020 Is there a question here? If you're just showcasing your work, we have a Showcase section here, where you can post your finished work: https://www.cadtutor.net/forum/forum/9-showcase/ Quote
ammobake Posted July 22, 2020 Posted July 22, 2020 not bad tho. what exactly is the purpose of this contraption? lol Quote
SLW210 Posted July 23, 2020 Posted July 23, 2020 It would also be nice to include the software used to create the model. Quote
nukecad Posted July 23, 2020 Posted July 23, 2020 (edited) On 22/07/2020 at 23:51, ammobake said: what exactly is the purpose of this contraption? Fixed to the transom for lowering/lifting jet-skis in and out of the water perhaps? It would appear that as the clyinder is extended the horizontal platform arm decends (on an arc) whilst staying horizontal. Without any measurements the movement of the platform arm looks to be about twice the stroke of the cylinder. It also looks like there is a transfer of the chain from below the small sprocket to above it as the arm descends? Unless done carefully that could bind up. TBH I'd have thought that it could be done more robustly (and cheaply) with an offset parallel linkage rather than all that chain and sprocket arrangement. Even easier, more robust, and cheaper with a longer stroke ram going straight up and down. If pushed for mounting space two stage double acting rams are readily available, I used to design hydraulic rams including multi-stage double actors. (Chain drive sprokets and salt water tend not to get on well together). Edited July 24, 2020 by nukecad 1 Quote
BIGAL Posted July 24, 2020 Posted July 24, 2020 (edited) Agree any one with a boat and saltwater will know that a chain is just a no no. Link arms yes. Had a steel chromed ladder lasted 1 season. Edited July 24, 2020 by BIGAL Quote
nukecad Posted July 24, 2020 Posted July 24, 2020 I do remember once designing a skip loader platform for use on a fleet of fishing trawlers, it was a variant of one that we fitted to trucks and lifted skips full of fish out of the hold and onto the quayside. Chromed rams and everything else hot dip galvanised. That would have lifted jetskis easily. Although that one was perhaps not pretty enough for a leisure boat I'm sure it could be prettied up to look, and even act, like a boat spoiler when not in use. Quote
ammobake Posted July 24, 2020 Posted July 24, 2020 (edited) Would agree there Bigal. Apparently, these are usually a frame consisting of series of stainless steel components with bolt linkage - with either one cylinder or two for larger lifts/vessels. Sealift USA has some of these https://www.sealiftusa.com/lifts -ChriS Edited July 24, 2020 by ammobake 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.