Jimbo720 Posted November 24, 2018 Posted November 24, 2018 In this drawing the angled lines are parallel but when I make them that way it looks wrong (I know I'm missing the holes in both views). Below I attached my drawing and am hoping you can tell me my errors. Thanks! EX09-29.dwg Quote
steven-g Posted November 25, 2018 Posted November 25, 2018 The three angled lines in the left diagram are indeed parallel, but there is no starting point measured for the center of those 3. You have assumed that the angle of the diagonal in the right hand diagram is the same as those in the left (mirrored) it isn't! The only given is the lower starting point of that diagonal. If you first construct the front view you can find the correct top starting point for the middle of the 3 left diagonals. And then from there start constructing the auxiliary view of the cut plane. 1 Quote
Jimbo720 Posted November 25, 2018 Author Posted November 25, 2018 (edited) Thank you for your help! This is my attempt I think it's okay but I'm not sure. I Think some of the features in my primary auxiliary are wrong. EX09-29.dwg Edited November 25, 2018 by Jimbo720 Quote
Jimbo720 Posted November 25, 2018 Author Posted November 25, 2018 Something strange happened when I uploaded that one I'm going to try again. EX09-29.dwg Quote
Jimbo720 Posted November 26, 2018 Author Posted November 26, 2018 Awesome, thanks for your help! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.