setting default label style

[sandiegophil]

Hello,

 

When I add geometry point labels to an alignment I always have to use the drop-list for 'geometry point label style' and pick the style I want. Does anyone know how/where to set the default for this?? Any and all help is appreciated.

 

Thanks,

phil

[MillerMG]

have you tried just deleting the standard one that it defaults too?

[sandiegophil]

MillerMG,

 

That did change the default, thank you. However the default is now the 1st label style listed alphabetically. Any further suggestions would be appreciated.

 

thanks,

phil

[MillerMG]

This is a bad solution and may not even work but put a 1 in front of your style name. It might work. It also probably isn't the solution you're looking for.

[sandiegophil]

hehehe underscore, 01, 1, all work as you suggested. I just would prefer our template to not have something like that in it. makes it look like I can't figure it out. which is true, I can't so far. Your help is greatly appreciated, any additional thoughts and/or suggestions are welcome.

 

thanks again,

phil

[MillerMG]

Did it at least achieve your original goal? I know it wasn't the way you wanted it but does it at least work for you?

[sandiegophil]

I tried saving a copy with a 01 prefix, an underscore, forcing it alphabetically to the top and it still defaults to the same style.

 

I had it report where the style occurs and it is only in a lable set that is not applied in the drawing...