d1212 Posted October 7, 2015 Posted October 7, 2015 Hello Community, is there a way to keep the fill of a MLINE after I explode it? I'd like to have single LINES with a HATCH. Or is there a diffrent way to achieve this? I'd like to draw e.g. two lines with a solid hatch in between at once. Thanks and kind regards d1212 I use AutoCAD 2016 Quote
Organic Posted October 18, 2015 Posted October 18, 2015 I haven't found a way to do this although having needed this previously it would be very handy if there was a way. Quote
BIGAL Posted October 19, 2015 Posted October 19, 2015 A custom pline routine would be the way to go offset 2nd line then close ends, and join then hatch. Need a couple of rules is it central or a left/right offest as you draw. There should be something already out there, I think I have seen something about closing two plines. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.