kifmarn Posted January 6, 2015 Posted January 6, 2015 I recently updated to Inventor 2015 and since then tapped holes are not displaying correctly in idw. They only show the core drill. My custom hole chart identifies them as tapped holes correctly but I want them to display correctly in the drawing also. Any ideas? Is there a simple setting I have overlooked? Kev. PUNCH BOLSTER 2.zip Quote
kifmarn Posted January 12, 2015 Author Posted January 12, 2015 OK, looks like nobody else knows... I found the solution anyway; in the display options there is a tickbox 'Thread Features' which needs to be ticked. It must have been on by default in previous versions as I never needed to do this before? I have attached a jpeg for reference. Quote
gbradley Posted January 12, 2015 Posted January 12, 2015 Thanks for Replying to your own thread with a good explanation. My tick box was unchecked too. The picture is worth, well you know 1,000 words. So much better than "Never mind I figured it out" Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.