Hrki Posted May 23, 2014 Posted May 23, 2014 http://www.cadtutor.net/forum/showthread.php?86568-Default-AM_-layers-edit Is that normal????? Quote
dbroada Posted May 23, 2014 Posted May 23, 2014 not normal but I have seen it a couple of times. Usually when a person with few posts shares a link. These have to be cleared by a moderator. Did your post have a link in it? Quote
dbroada Posted May 23, 2014 Posted May 23, 2014 I expect that is it then. I am sure a moderator will be along soon. I have just looked and none are on at present but the European ones can't be far away. Quote
Hrki Posted May 23, 2014 Author Posted May 23, 2014 Ok, no problem i didn't know what is going on Quote
ReMark Posted May 23, 2014 Posted May 23, 2014 Anything suspicious about the link you posted that we should know about? Quote
RobDraw Posted May 23, 2014 Posted May 23, 2014 I wanted to respond to that post but the question was too clear. Quote
Cad64 Posted May 23, 2014 Posted May 23, 2014 http://www.cadtutor.net/forum/showthread.php?86568-Default-AM_-layers-edit Is that normal????? Your post was moderated by the forum software, for some reason, and needs to be approved. I have tried to approve it but it is still showing as being moderated. I have left a message for the forum administrator to take a look. Sorry for the inconvenience, hopefully this will be resolved soon. Quote
CADTutor Posted May 25, 2014 Posted May 25, 2014 The post is now visible. The external link required moderation - you could use the attachment feature to avoid this in future. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.