Rotate Spur Gear?

[Faouweb]

Hi,

How can I rotate a Spur Gear as you can see on the picture.

http://s3.postimg.org/wbwxx2soz/rotation.png

Thank you

[JD Mather]

Add an angle constraint and then Drive Constraint

or

in Environments>Dynamic Simulation add a Rolling Cylinder on Cylinder joint and then Imposed Motion on Revolution joint.

 

If you can't figure it out - simply attach your assembly here.

[Faouweb]

Add an angle constraint and then Drive Constraint

I don't know how to do it

 

 

in Environments>Dynamic Simulation add a Rolling Cylinder on Cylinder joint and then Imposed Motion on Revolution joint.

We don't have Inventor Pro

I have attached 2 Parts and 1 Assembly.

Thank you

Assembly1.zip

Spur Gear test.ipt

Part8.ipt

[JD Mather]

You have attached the wrong files which will result in a delay in getting an answer.

Have you installed all Service Packs for r2013? (the correct answer is - no)

[Faouweb]

Hi Mather,

The file is a little bit big and I can not attached it, I used Pack and go but is still big.

I will put the Assembly and the Part in the attachment.

Here is what I have.

 

 

 

 

I did not installed it my self, we have a staff in the company which have access in order to install or modify applications.

 

 

---------------------------- Edit ---------------------

Is there a step by step tutorial to do it ?

Thank you

Part1.ipt

Design Accelerator.zip

Assembly1.zip

Edited May 19, 2014 by Faouweb

[JD Mather]

Step 1

Right click on you Design Accelerator sub-assembly and set it to Flexible as shown below.

 

 

You should now be able to drag the gear motion.

Next I will demonstrate how to Drive the motion.

 

(also notice in the image above your assembly references Part8, yet you attached a Part1?)

[Faouweb]

Thank you very much JD Mather , I can rotate the Gear

[Faouweb]

I am so happy to see the Gears rotating, but I want to add some Gears and V-Belt to make something more complicate.

How can I add Gear or V-Belt to existing one, I have tried but I am sure it's not a the good way to do it as you can see in the picture:

http://s10.postimg.org/hk0b8baax/belt.png

Thank you

[JD Mather]

Notice that your gears created by the Design Accelerator are placed in a special sub-assembly in the browser and must be created in pairs.

I simply drill down and get the *.ipt files and use these like any other parts in my own assemblies and sub-assemblies.

[Faouweb]

Is that correct?

http://s12.postimg.org/7rznu33x9/belt1.png

 

 

I tried to move the Spur Gear1:1 which is in red square to the Spur Gears:1 ( the special sub-assembly ) but it does not want to move, even if I change the name.

 

 

Thank you for your help and your patience

[JD Mather]

I don't go to 3rd party websites.

[Faouweb]

I don't go to 3rd party websites.

Sorry