Jump to content

How to stack fractions in block attributes


Recommended Posts

Posted

I am presently working on a P&ID drawing and there are numerous small size pipes, valves and reducers and I would like to use vertical stacked fraction. I am presently empting the attribute and putting a Mtext in its place. It is slow and troublesome.

 

Can someone tell me how get Mtext into the block editor so I can use it instead of single line text when I am creating block attributes?

Posted

You should be able to just write multiline text in a block editor same as anywhere.

 

For ATTRIBUTES to be multiline....

Just select Multiline text in the attribute editor or properties. When creating an attribute you can select multiline also.

 

[ATTACH=CONFIG]39611[/ATTACH]

 

[ATTACH=CONFIG]39612[/ATTACH]

 

[ATTACH=CONFIG]39613[/ATTACH]

Posted

Thank you SLW210 for your reply.

 

I have tried setting the attribute to Multiple lines when I define the attribute, but it does not give me the option to stack the fraction like it does when I select multiple line text under the Draw tab. However it does allow multiple lines

Posted

Sorry, I forgot to mention..

 

ATTIPE=1 will use Full Text Editor with Attributes.

  • Like 1

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...