Penn Foster Student Suffering with Oleson Village Map!!!

[Kayy]

I’m sorry to be a pain I found the bearing but when I put it in Autocad it says invalid 

[BIGAL]

Try like this.  @226.4<S50d43'14"E

 

Note the "d" or "D" 

[ReMark]

On 3/2/2025 at 5:12 PM, Kayy said:

I’m sorry to be a pain I found the bearing but when I put it in Autocad it says invalid 

I'm sorry you are having trouble but this is the same method used to put in all the boundary lines so it is possible you just mis-typed something.  Even something as minor as a missing < ' > symbol will cause an error message to pop up.  Follow BIGAL's advice and you should be fine.

Edited Tuesday at 11:10 AM by ReMark

[Kayy]

Hey @ReMark can you help me on the lot 7 and 8 I’m not sure if I’m putting the Measurements in right?

[ReMark]

Lots 7 & 8 are the same size... 60 x120.  The 120 ft dimension is perpendicular to the north street line of SW Village Lane while the 60 ft dimension is parallel to the north street line of SW Village Lane.  To create the easterly property line of lot 7 offset the westerly street line of SW Oleson Road a distance of 50 ft.  Offset that line 60 ft to the west.  Then offset that line another 60 ft. to the west.  Offset the northerly street line of SW Village Lane 120 ft. and trim everything up as required.