Hatch get's messed up when exporting to eps

[daer]

Hi,

 

I 'm new to this forum. I hope I could find an answer to my question. I exported a dwg as .EPS and opened it up in Illustrator. Everything is fine except from the hatch, which looks like this:

 

 

and below is how it normally looks like in Autocad.

 

 

I tried exploding the hatches and exporting to EPS again, but no change. I am using Acad2013 (mac) and I 've experienced this again in previous mac versions. I haven't tried in windows. Finally, I noted that although most hatches get messed up, there are a couple that don't(confusing right?).

 

I would greatly appreciate some help.

[daer]

Please any ideas? This has been viewed 83 times yet no reply. .

[hugha]

Try opening the .EPS in another viewer - there's quite a few out there to be found by searching for "eps file viewer" to show whether the problem is in the file as exported or in Illustrator's private interpretation.

 

This may help:

http://forums.autodesk.com/t5/AutoCAD-2004-2005-Archive/DWG-to-EPS-Conversion/td-p/1689904