Solid Editing Problems After Using Slice Command

[sua]

First of all Hi to everyone!

 

When I use slice command in a 3D model, after separation into two parts, each part can't editable, you can only move them.

 

You can see in arrows on # 1 and # 2 3D model, but after using separate into it two parts by slice command , these arrows are disappeared.

 

How can I see arrows again to change dimensions of 3D model easily?

 

I hope that you can understand what I mean.

 

 

PHOTO LINK: http://imageshack.us/photo/my-images/171/sliceproblem.jpg/

Edited November 19, 2011 by sua

[SLW210]

Why not post your image here?

 

Once you edit a 3D model with slice you lose the ability to use grips for modifications.

[sua]

@SLW210

 

- Thanks for your answer. It's too disappointing!

 

BTW I have tried it but I can't upload from "insert image" , I don't know the reason why.

[SLW210]

Select "Go Advanced" at lower right of reply box, then select "Manage attachments" to post image here.

 

You should use the _SOLIDEDIT command to make modifications, just no more using the grips.

[sua]

@SLW210

Thank you.

[JD Mather]

A solid part can always be edited.

[SLW210]

A solid part can always be edited.

 

Not with the grips, that was the initial question.

[sua]

While I was trying to edit my first message, it was disappeared. I don't know why had happened?

 

Anyway; I will post first message to here again:

 

(removed duplicate information/ Tiger)

Edited November 21, 2011 by Tiger
Removed duplicate information

[Tiger]

While I was trying to edit my first message, it was disappeared. I don't know why had happened?

 

Anyway; I will post first message to here again:

 

(removed duplicate information/ Tiger)

 

There are restrictions set in place in this forum that limit users with less than 10 posts to post links. So when you edited the post, you added a link and that got your message moderated. I have now approved your post but I recommend that you read the posting guidelines here: How Do I Make A Post?