andazw Posted August 12, 2008 Share Posted August 12, 2008 its been 3 years since i did my btech national on CAD then then moved onto the shop floor, so obviously am very resty at this i have to circles not exactly opposite each other but about 120mm apart what i need to do is put an arc between these to circles at R90 but there is a certain way to do this which i habe forgotten, the fillet command doesnt work either in the attachment i have made a tangent line where the arc is supposed to be, help would be appreciated... activity 14.dwg Quote Link to comment Share on other sites More sharing options...
lpseifert Posted August 12, 2008 Share Posted August 12, 2008 Circle > TTR >Trim Quote Link to comment Share on other sites More sharing options...
andazw Posted August 13, 2008 Author Share Posted August 13, 2008 thanks very much Quote Link to comment Share on other sites More sharing options...
daveyboyd Posted August 13, 2008 Share Posted August 13, 2008 >arc - Start, End, Radius Also Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.