Search the Community
Showing results for tags 'daylight'.
-
Hello all, How can I create a smooth transition between subassemblies with different daylight slopes? I have a corridor with 2 subassemblies used. I set the regions up so type 1 is from Sta. 0+0 to 0+100, type 2 from 0+100 to 0+125, and then from 0+125 to end is type 1 again. The daylight slope for type 1 is 1.5:1 and it is 100:1 for type 2. Thanks in advance, Kyle
-
When creating an assembly with daylight lines, I use the DaylightGeneral subassembly and add a material thickness to show the depth of the material. One thing I cannot figure out is how to change the linetype of the bottom of the material. The link code for the bottom line is "Datum", so if I change that in my code set style, then it will change all of the datum links to the different linetype. Does anyone know if there is a way to change this without creating a custom subassembly? Thanks.
-
Greetings all! I have a dilemma that I thought sounded pretty straightforward, but have discovered it is not. I have a levee for a project involving wetlands and each levee has an alignment, profile and corridor associated with it. My problem is that I have different sideslopes along the levee you see. I have places where the side slopes are 10:1 and then go to a 4:1 and THAT is where my problem and question is. I have an assembly with a 10:1 slope, I have an assembly with a 4:1 slope; how do I properly make the transition between the two assemblies inside of my corridor? Here is what I have done thus far: I created an additional assembly that had just the levee top. I broke the corridor into 3 regions and thought that if I had a region with the 10:1 assembly, a region with the levee top only assembly, and then the 4:1 assembly the corridor would transition the daylights between the two, but alas it does not. Any help, or suggestions would be greatly appriciated. Thank you for reading. Sincerely, Mike