Search the Community
Showing results for tags 'batting line'.
-
My batting linetype was showing up perfectly until I opened my drawing file today. Now it shows up as a dotted line. I tried MSLTSCALE, PSLTSCALE, LTSCALE, etc. I tried changing the scales manually. When I go to "load" it again it says "Bad definition of FENCELINE1 at line 119 of file / Users/***********/Library/Application Support/Autodesk/roaming/AutoCad 2013/R19.0/enu/support/acad.lin" I can't even access as far as "Library" via Finder. How do I reload ACAD.LIN altogether or make it work?
- 8 replies
-
- linetype
- batting line
-
(and 2 more)
Tagged with:
-
Batting line looking different in the viewport ?
Wievior posted a topic in AutoCAD Drawing Management & Output
Hi everyone, I'm new to the forum and new to AutoCAD in general. Trying to create an insulation batting line (15 centimeters wide), in the model it looks okay (actually it goes a tiny little bit beyond the borders, but it is good enough for me at this stage). In the viewports however it is much wider (I would say, it is 10-15 times wider than expected). I've googled the problem (that's how I stumbled upon this forum) and found out that I'm not the only one having difficulties grasping the batting line thing. My setup: LTSCALE - 1.0 CELTSCALE - 1.0 MSLTSCALE - 1.0 I do realize that it probably a silly thing that I'm missing, but I can't seem to figure it out. Not sure what else can be wrong, any help would be greatly appreciated.