Hopefully can find some advice on creating a linetype from the ANSI 31 hatch type (/////////) I've read the many posts about creating linetypes but just can't figure this out..So far Autocad just gives me an error when I try and use 1/2 of the code from ZIG ZAG linetype below. Below that is what I have thus far. Any help would be greatly appreciated..we use this all day long at work and was hoping to turn this into an mline so I could just pic a point a long a wall (only 4" walls needed) and drag along as needed. Thanks again!
*ZIGZAG,Zig zag /\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/\/
A,.0001,-.2,[ZIG,ltypeshp.shx,x=-.2,s=.2],-.4,[ZIG,ltypeshp.shx,r=180,x=.2,s=.2],-.2
ANSI31, ANSI31 ////////////////////////////
A,.0001,-.2,[ANS,ltypeshp.shx,x=-.2,s=.2],-.4