extruding/pushpull a large array of circles

Hi All,

I need to design a 'stencil' of sorts - but it just needs to be an array of circles separated by a constant distance. its an array of 200 micron diameter circles separated by a distance of 500 microns each (between centers).

Its super easy to make this array, but when I try to 'pull' it into the third dimension, or extrude the array, I get an 'invalid' error. Or the highlighted objects just get 'unhighlighted' (for the lack of a better word) once i hit enter after selecting them all.

Also, I made the entire array into a 'block' of easiness.

Any help is hugely appreciated!

Thank you!

Mukul

Extrude or presspull one circle into a cylinder and then array that.

So easy!

hahaha.. really? i was going the other way around. okay. thanks. lemme try this out.